Place the projector near a wall socket with an easy-to-unplug plug.Consult your dealer or the power company if you are unsure about the electricity available. Use the power supply that the projector specifies.Use the projector away from water and heat sources.When setting up and operating the projector, follow these safety precautions: Do not put the projector on a cart, stand, or table that is shaky.However, the light blinks when the module is communicating over the network. When the wireless LAN module is installed and used, the module’s indicator lights up. ![]() VIDEO DEVICEĬonnect various media devices and switch between them using the Source Search button on the projector or remote control. HDMI PORTĬonnect one end of an HDMI cable to the HDMI connector on the projector and the other end to an HDMI port on your device. There is an option to connect an audio cable. Always make sure that the laptop is set to external display mode (see “Troubleshooting” in this article). ![]() You can connect one end of a VGA cable to the computer port of the projector and the other end to the monitor port on your device. ![]() To install the Epson USB Display software, double-click USB Display Installer and follow the on-screen instructions (only on the first connection). The USB Display setup folder shows in the Finder when you switch on the projector. If the software screen does not appear automatically, go to My Computer or Computer and double-click EPSON PJ UD. Connect the cable’s flat end to any USB port on your computer.įollow the on-screen instructions to install the Epson® USB Display software after powering the projector. ![]() You can connect the square end of a USB cable to the square port of USB-B on the projector.
0 Comments
Leave a Reply. |